Potassium hydroxide cutting is the key process of product processing process. Its processing efficiency and quality are directly related to the overall production. Therefore, when cutting products, we need to operate in strict accordance with the requirements. Here are the principles of cutting process:

　　1、切割精度高、表面平行度高、翹曲度和厚度公差小。

　　1. High cutting accuracy, high surface parallelism, small warpage and thickness tolerance.

　　2、斷面完整性好，拉絲、刀痕和微裂紋。

　　2. Good section integrity, eliminate drawing, knife mark and micro crack.

　　3、提高成品率，縮小刀（鋼絲）切，降低氫氧化鉀損耗。

　　3. Improve the yield, reduce the knife (steel wire) cutting, reduce the loss of potassium hydroxide.

　　4、提高切割速度，實現自動化切割縫。

　　4. Improve cutting speed and realize automatic cutting seam.

　　以上是關于氫氧化鉀切割工藝技術的要求，那么只有在運行中按照正確的準則操作才能獲得合格的產品，如果稍有不慎就會造成不必要的麻煩，因此小編建議大家按照嚴格要求進行。

　　The above is about the requirements of potassium hydroxide cutting technology, so only in operation according to the correct guidelines can we get qualified products, if there is a little carelessness will cause unnecessary trouble, so we suggest that we carry out according to strict requirements.

　　本文由http://www.yiqijieneng.cn發布

　　This article is published by http://www.yiqijieneng.cn